silver

Tricks to making small silver balls for sterling silver decoration….(does that make sense? hahaha)

So I just started trying to make these little silver accent balls for my jewelry.  Some tricks and lessons learned:

Use fine silver, not sterling silver.  Take any leftover fine silver bezel wire and melt those down into balls.  Try to keep the strips you cut the same length.  If you make the balls too big they have a tendency to collapse in on themselves and not create a nice round ball.  If you want the balls to be flat on one side solder them on a flat surface.  However, if you would like your silver balls to have a perfect spherical shape you can dig out a little hole in your soldering block, this will keep the silver from forming a flat side.

Adhering the balls to the surface is just that easy, file one side of your ball so it has a flat surface to sit on, otherwise it may roll on you during soldering.  Place a small piece of medium solder under your ball and heat.  Easy as that!!

key take aways:

  • use fine silver scrap
  • don’t make them too big, they won’t hold their spherical shape
  • dig out a little hole in your soldering block to make perfect spheres
  • use medium solder (depending on your design and steps/order of your process)

 

 

Image

How to etch sterling silver

So many of you on Facebook have been asking about how I do this so I thought I would share in more detail here.  I hope you find it useful.  

I will start off by saying, for etching sterling silver I use Ferric Nitrate.  You can buy this from The Science Company online usually in 500grams or more.  When you get it you have to mix it with water to make the solution, probably fairly obvious I know ;o)  I don’t have a solid recipe that I use but I will say I use about two cups of warm water to about 1 cup of crystals. I have a magnetic stir plate that mixes the solution for me and agitates it while I etch.  You just place a magnetic pill in the solution and the magnet inside the base plate rotates, rotating the pill and mixing the solution.  It is extremely handy and I believe can be purchased on Rio Grande but it wouldn’t hurt to check Craigslist or something.

Once the solution is mixed your ready to prep your piece.  A lot of places tell you to use permanent marker or even wax to create designs but I find that the marker comes off very easily in the solution.  Roughing up your surface a little might help with the marker but then you have etched texture (which may look cool) from the rough surface.  I prefer to use some kind of sticker.  It adheres really nicely to the surface and it gives me a nice clean edge when I etch.  You can find stickers of all different kinds at your local craft store, or you can buy some vinyl and cut out any shapes you want.  You will be super happy with the results.  

Depending on the strength of your etch, if its fresh I usually leave it in for about 1 hour to start.  When you take it out to check it you may have to gently wipe away some of the silver that has etched on the surface but has not fallen off.  Rinse and check it once in awhile until you achieve the desired depth.  When you are happy with the etch, remove the pattern and wash the piece with a soft tooth brush and dish washing liquid like Dawn.  I don’t recommend that you use the tooth brush for anything other then cleaning your pieces from that point on ;o)  

some quick tips:

  • I use reverse tweezers to hold the piece in the solution.  You can also punch a hole and hang it off the side of the container with some insulated or coated wire.    
  • agitating the solution helps with the etching process.
  • the solution will stain your skin so be sure to wear the proper protection if you want your skin color to be normal ;o) 
  • make sure the piece is free and clean of any greasy finger prints because it will etch your finger prints into the metal

Well look, if I’ve missed something don’t hesitate to add comments or ask questions :o)  Thanks guys!  I hope this helped and happy etching!

 

Image